Next adjust the angle on the floor scraper until it pulls up vinyl without gouging the subfloor.
Best way to pull up sheet vinyl.
Use a floor scraper or painters tool scraper to pull up stubborn sections and adhesive.
Start by working your scraper or the edge of your oscillating multitool.
Spread the adhesive with a notched trowel.
Use a notched trowel 1 16 x 1 16 x 3 32 in.
Resist the urge to pull up the sheet with your hands.
Use power to chip out floor tile.
Precisely position the vinyl flooring in the bathroom then reroll one half of the piece.
Remove the top layer of linoleum first.
Remove the flooring with a hand held floor scraper after putting on work gloves.
Holding the heat gun too close to flammable materials can ignite a fire.
Cut into 12 inch strips.
This makes removal of the vinyl sheet easier.
You ll go back later to pull up any remaining paper backing and or adhesive.
Pull up on the.
Then turn it on and let er rip photo 2.
Roll back the second half of the floor and repeat the gluing process.
Once you ve removed as much as you can with the prybar use the 5 in 1 tool or any floor scraper tool to scrape off the.
If you notice part of your design lifting up you can just hold it down with your finger while you pull off the vinyl surrounding it.
Get rid of the glue.
Pull or scrape the flooring off of a concrete subfloor if moisture is damaging it.
You ll probably be able to pull the vinyl off of the wettest areas without scraping.
Be very careful about keeping the heat gun far enough away from the work materials and be sure to wear gloves.
Insert the blade of the scraper under the loosened edge of the flooring and lift up on the handle.
Notches to spread the adhesive evenly over the floor.
Use the flat end of the pry bar to chip away at the glue underneath the vinyl.
The concrete probably hasn t.
Start at a corner and slowly pull the vinyl up at an angle making sure all the parts of your design remain attached to the carrier sheet.
Instead cut the vinyl in narrow strips.